:max_bytes(150000):strip_icc():focal(749x0:751x2)/amazon-glp-1-042226-c541da30e4d5438187dea6b679d7d096.jpg)
★★★★★ 5
Quality product you
Model: 18 SqFt(1.7 SqM), Model: 18 SqFt(1.7 SqM)
Summary: Great quality product, priced right. Cuts and installs easy-follow the instructions people!! PRO TIP-you don’t need to cover every square inch. OVERKILL!! Think about it-when a bell rings you could put your fingers on the edge and silence it right? Same rules apply here. A strip or square will isolate the vibration and notice when placed correctly— knock on the surface and see what vibrates or what part makes the loudest drowning and that’s a good clue of where you should put a piece of this…unless you’re trying to use it for temperature insulation no need to go ape on it. If you look at the bottom of a stainless steel sink, it’s got a stripe or a small sticker of insulation that keeps it from rattling. You can do that here. What’s important to note is the instruction specifically say use a roller to roll the ribs out until it’s smooth that way you’ve got maximum adhesion. I see a lot of pictures and videos from people that finished their install and didn’t follow this simple instruction. It makes sure that it’s stuck down before you put all your paneling and carpet back in and it’s a small step with a cheap wooden roller it’s easy. I’ll say the installation with this product is a breeze. You can use sharp scissors or a blade. It does get gummy after a while, and you may need to clean off your blade or your scissors, but it cuts very well and the ribs make it easy to size in space the thickness is fantastic and the backing paper comes off quite easily. I’ve done lots of installations with Graphics emblems you name it and this product is very easy to use and represents good value.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on March 30, 2026
